Schematics:

The following Page describes the schematics of the board:

Then Board with all components

OpenZapper_Board.png

The board schematic

OpenZapper_Schematic.png

!!List of Components:
  • 1 Fuse holder (Package SH22.5A): Accept 20mm Fuse. Fuse holder dimentions: 22.5x9mm
  • 1 Fuse (500mA) should be enough, even 200mA should be fine
  • 1 220uF 16V radial capacitor (package E5-10.5 => 10.5mm diameter, 5mm inter pins
  • 1 100nF 50V film capacitor package C050-025x075 7.5mmx2.5mmx5mm
  • 4 1N4004/1N4007 power rectifier diodes
  • 2 terminal blocks (5mm spacing)
  • 4 microswitch (omron B3F-10XX)
  • 1 1Kohm Variable Resistor (package CA9V )
  • 3 Leds (1 x blue/green, 1 x yellow/orange, 1 x red)
  • 1 BC547 NPN transistor
  • 4 1Kohm 1/4 watt resistor
  • 2 330 ohm 1/4 watt resistor
  • 2 30Kohm 1/4 watt resistor
  • 1 DIP 16 IC support
  • 1 CD4049N MOS IC chip
  • 1 Arduino pin set or 40 Pin 2.54 mm Single Row Pin Header Strip (http://www.ebay.com/itm/3-PCS-40-Pin-2-54-mm-Single-Row-Pin-Header-Strip-/260798967749?pt=LH_DefaultDomain_0&hash=item3cb8d46fc5)
  • 1 2x16 char LCD screen (compatible with HD44780 controlers)
  • 1 LM7809 voltage regulator
  • 1 Netduino Plus 2 (http://netduino.com/buy/?pn=netduinoplus2)

Last edited Jul 27, 2013 at 3:25 PM by Nutz95, version 4

Comments

No comments yet.