Comments

Coordinator
Jul 27, 2013 at 4:18 PM
Please place here your comments/suggestions.
Coordinator
Nov 9, 2013 at 1:10 PM
I've updated the OpenZapper box, both top and bottom, to allow easier screwing/unscrewing of both power supply and zapper rods to connectors.
-> I added 2 holes on the top cover.
I also closed the hole on top of the Fuse + Capacitor. FOr this i needed to make the top cover thicker (I added 4mm).
The hole for the Status led has also been enlarged.

On the bottom piece a hole has been made in order to be able to connect the microUsb cable to the Netduino Board.
This should allow easier programming without removing the board from it's box.

About the SD card the Netduino is too far from the box so i didn't make any additional holes for it.
Maybe on a future release of the board i'll make sure the netduino board is on the edge of the box, so that we will be able to remove/replace the SD card easily.
Coordinator
Nov 14, 2013 at 9:43 PM
I'm testing the models right now.
The current Bottom box USB hole is not properly aligned with the Netduino Board.
I'll print the Top box soon to test the V2 Model